Wikipedia

Cog (ship)

A cog is a type of ship that was used during the Middle Ages, mostly for trade and transport but also in war. It first appeared in the 10th century, and was widely used from around the 12th century onward. Cogs were clinker-built, generally of oak. Cogs were fitted with a single mast and a single square sail. They were used primarily for trade in north-west medieval Europe, especially by the Hanseatic League. Typical seagoing cogs were from 15 to 25 meters (49 to 82 ft) long, 5 to 8 meters (16 to 26 ft) wide, and were of 30–200 tons burthen. Cogs were rarely as large as 300 tons although a few were considerably larger, over 1,000 tons.

A replica of the Bremen cog

Although the name cog is recorded as early as the 9th century, the seagoing vessel of that name seems to have evolved on the Frisian coast during the 12th century. Cogs progressively replaced Viking-type vessels such as knarrs in northern waters during the 13th century. Cogs could carry more cargo than knarrs of a similar size. Their flat bottoms allowed them to settle on a level in harbour, making them easier to load and unload. Their high sides made them more difficult to board in a sea fight, which made them safer from pirates.

Description and construction

edit
 
A comparison of clinker and carvel construction. Carvel frames are much heavier than clinker ribs.

Cogs were a type of round ship,[1] characterized by a flush-laid flat bottom at midships which gradually shifted to overlapped strakes near the posts. They were propelled by a single, large, rectangular sail. Typical seagoing cogs ranged from about 15 to 25 meters (49 to 82 ft) in length with a beam of 5 to 8 meters (16 to 26 ft) and were 40–200 tons burthen. Cogs were rarely as large as 300 tons, although a very small number were considerably larger, over 1,000 tons.[2][3][4][5] A rule of thumb for crew size was that one sailor, exclusive of any dedicated fighting men, was required for every 10 tons burthen of the cog, although this may generate a suggested crew size on the low side of Medieval practice.[6] Crews of up to 45 for civilian cogs are recorded, and 60 for a 240 ton cog being used for military transportation.[7]

 
Stern-mounted rudder

Cogs were typically constructed largely of oak, and had full lapstrake, or clinker, planking covering their sides, generally starting from the bilge strakes, with double-clenched iron nails for plank fastenings. At the stem, chases are formed; that is, in each case, the land of the lower strake is tapered to a feather edge at the end of the strake where it meets the stem or stern-post. This allows the end of the strake to be fastened to the apron with the outside of the planking mutually flush at that point and flush with the stem. This means that the boat's passage through the water will not tend to lift the ends of the planking away from the stem. Before the next plank is fitted, the face of the land on the lower strake is bevelled to suit the angle at which the next strake will lie in relation with it. This varies all along the land. The new strake is held in position on the preceding one before the fastening is done.[8][9]

The keel, or keel-plank, was only slightly thicker than the adjacent garboards and had no rabbet. Both stem and stern-posts were straight and rather long, and connected to the keel-plank through intermediate pieces called hooks. The lower plank hoods terminated in rabbets in the hooks and posts, but upper hoods were nailed to the exterior faces of the posts. Caulking was generally tarred moss that was inserted into curved grooves, covered with wooden laths, and secured by metal staples called sintels.[8] The cog-built structure would be completed with a stern-mounted, hanging, central rudder on a heavy stern-post, which was a uniquely northern development.[10] The single, thick, mast was set forward of amidships, stepped into the keel-plank and equipped with a single large, rectangular, square-rigged sail.[11][9] The masts of larger vessels would be of composite construction.[12] Complicated systems of rigging were developed to support the mast and to operate the sail.[13] Cordage was usually hemp or flax[note 1] and the sail hemp-based canvas.[14] From the 13th century cogs would be decked and larger vessels would be fitted with a stern castle, to afford more cargo space by keeping the crew and tiller up, out of the way; and to give the helmsman a better view.[15]

 
Cross-section of hull; note the lower mast stepped and braced

A cog, compared with the carvel-built vessels more traditional in the Mediterranean, was expensive and required specialist shipwrights. However, their simpler sail setup meant that cogs only required half the crew of similar-sized vessels equipped with lateen sails, as were common in the Mediterranean.[16] A structural benefit of clinker construction is that it produces a vessel that can safely twist and flex around its long axis (running from bow to stern), which is an advantage in North Atlantic rollers, provided the vessel has a small overall displacement. A limitation of cogs is that they lack points to mount additional masts: at least some fore-and-aft sails are desirable for maneuverability but clinker-built cogs were effectively limited to a single sail.[17][18] This made them unhandy, limiting their ability to tack in the harbour and making them very reliant on wind direction at the start of voyages.[17][19] The flat bottom permitted cogs to be readily beached and unloaded at low tide when quays were not available; a useful trait when purpose-built jetties were not common.[11] Cogs were expected to have a working life of approximately 40 years.[4][note 2]

History

edit
 
The 1223 seal of Lübeck, one of the leading cities of the Hanseatic League. It depicts an earlier form of cog with side rudder and curved stem and stern posts.

The earliest origins of the cog are believed to be logboats from around northern Germany. These developed into larger craft built in the same basic shape, but with planking instead of hollowed-out logs. Another development was into Kahnen, flat-bottomed boats, with pointed ends for and aft that were constructed by splitting a hollowed-out log and widening the bottom with planks that were nailed to knee-shaped ribs attached to the sides. The pointed ends (called Block locally) of the log would be cut off and attached separately to the widened hull which resulted in so-called Blockkahnen, variants of which are still in use. The earliest evidence of a cog-like craft is a clay model found in Leese on the middle Weser from the grave of an adult male who died around 200 BC. Fragments of similar clay models have been found in nearby regions.[20]

Trade from Germania in Roman times was mostly carried on Mediterranean-style sailing vessels and controlled by Roman merchants. After Roman power collapsed in the middle of the first millennium AD, transports on the large river estuaries and the sheltered waters of the Wadden Sea was taken over by Frisians who used vessels based on indigenous, flat-bottomed designs that were precursors of later medieval cogs. These had much lower sides than later cogs and would have been very similar to contemporary Scandinavian craft, such as knarrs. The oldest depiction of a vessel identified by contemporary sources as a cog is the Lübeck city seal from 1223. The early cogs were fitted with a side-mounted rudder oar that also functioned as a leeboard and was rigged with a single broad square sail that functioned similar to a lug sail.[21]

Around 1200, the side rudder began to be replaced with a centerline rudder attached to a sternpost and developed in the typical medieval cog. Cogs could carry more cargo than knarrs; the rudder made steering easier than did the steering oar of the knarr, especially for larger vessels; and cogs were cheaper to build. The latter was due to the cog's use of sawn rather than split planks which was less wasteful.[15] Fore and stern castles would later be added for defense against pirates, or to enable the use of these vessels as warships.[22] The stern castle also afforded more cargo space below by keeping the crew and tiller up, out of the way.

 
The reconstructed Roland von Bremen based on the wreck of a cog from around 1380

Current archaeological evidence points to the Frisian coast or Western Jutland as the possible birthplace of this type of vessel. The transformation of the cog into a true seagoing trader came not only during the time of the intense trade between West and East but also as a direct answer to the closure of the western entrance to the Limfjord. For centuries, the Limfjord in northern Jutland offered a fairly protected passage between the North Sea and the Baltic. Due to its unusual geographical conditions and strong currents, the passage was constantly filling with sand and was completely blocked by the early 12th century. This change produced new challenges. The larger ships, which could not be pulled across the sand bars, had to sail around the Jutland peninsula and circumnavigate the dangerous Cape Skagen to get to the Baltic.[23] This resulted in major modifications to old ship structures, which can be observed by analyzing the evolution of the earliest cog finds of Kollerup, Skagen, and Kolding. This caused a boom in the number of small cogs, and the need for spacious and seaworthy ships led to the development of the cog as the workhorse of the Hanseatic League.[23] It soon became the main cargo carrier in Atlantic and Baltic waters.[18][24]

Eventually, around the 14th century, the cog reached its structural limits, and larger or more seaworthy vessels needed to be of a different type. This was the hulk, which already existed but was much less common than the cog. There is no evidence that hulks descended from cogs, but it is clear that a lot of technological ideas were adapted between the two types.[10] The transition from cogs to hulks was not linear, according to some interpretations, both vessels coexisted for many centuries but followed diverse lines of evolution.[25]

Archaeology

edit
 
Reconstructed excavated cog from 1380 at Deutsches Schiffahrtsmuseum

The first archaeological find that was identified as a cog, was a ship wreck discovered in 1944 by P. J. R. Modderman in the Noordoostpolder near Emmeloord (plot NM 107). The wreck was reburied in situ and a 2008 re-excavation confirmed the interpretation as a cog. It was around 16 m long and its wood dated from 1339. The discovery by Modderman was however not well known in the literature.[26]

The most famous cog in existence today is the Bremen cog. The artifact originates from the 1380s and was discovered in 1962. Prior to this discovery, the existence of cogs was primarily documented in medieval texts and seals. In 1990 the well-preserved remains of a Hanseatic cog were discovered in the estuary sediment of the Pärnu River in Estonia which has been dated to 1300.[27] In 2012, a cog dating from the early 15th century was discovered preserved from the keel up to the decks in the silt of the River IJssel in the city of Kampen, Netherlands.[28] During its excavation and recovery an intact brick dome oven and glazed tiles were found in the galley as well as a number of other artifacts.[29][30]

In April 2022, a 13th-century cog was found in Tallinn, Estonia during highway construction. It is believed to be better preserved than the Bremen cog and a dendrochronology test on the wood has dated the wreck to 1298. The ship is 24 meters long and nine meters wide. The boards are intact up to three meters from the bottom of the ship.[31]

See also

edit

Notes

edit
  1. ^ Other materials were also used, for example walrus hide or human hair.[14]
  2. ^ In contrast, Mediterranean-type ships built contemporaneously in the French royal shipyard of Rouen had an anticipated life of three years in north European waters.[4]

Citations

edit
  1. ^ Rose 2001, p. 28.
  2. ^ Rodger 2004, p. 62.
  3. ^ Madden 2014, p. 104.
  4. ^ a b c Cushway 2011, p. 24.
  5. ^ Sumption 1990, p. 178.
  6. ^ Sumption 1990, p. 177.
  7. ^ Lambert 2011, p. 199.
  8. ^ a b Runyan 2003, p. 61.
  9. ^ a b Hutchinson 1994, p. 18–19.
  10. ^ a b Crumlin-Pedersen 2000.
  11. ^ a b Runyan 1994, p. 47.
  12. ^ Hutchinson 1994, p. 56.
  13. ^ Hutchinson 1994, p. 56–57.
  14. ^ a b Hutchinson 1994, p. 57.
  15. ^ a b Runyan 1994, p. 48.
  16. ^ Runyan 1994, pp. 49–50.
  17. ^ a b Friel 1994, p. 184.
  18. ^ a b Rodger 2004, p. 63.
  19. ^ Rodger 2004, p. 64.
  20. ^ Detlev Ellmers, "The Cog as Cargo Carrier" page 30-34 in Gardiner & Unger (1994)
  21. ^ Detlev Ellmers, "The Cog as Cargo Carrier" page 34-36 in Gardiner & Unger (1994)
  22. ^ McGrail 1981, p. 38.
  23. ^ a b Hutchinson 1994, p. 72.
  24. ^ Bachrach & Bachrach 2017, p. 167.
  25. ^ Gardiner & Unger 1994.
  26. ^ van Holk 2010, p. 125-127, 135.
  27. ^ Õun, Mati and Hanno Ojalo. 2015. 101 Eesti laeva. Tallinn, Kirjastus Varrak, page 12.
  28. ^ "Excavation, recovery and conservation of a 15th century Cog from the river IJssel near Kampen". Ruimte voor de Rivier IJsseldelta. Rijkswaterstaat. September 2015. Archived from the original on 6 July 2017. Retrieved 14 September 2017.
  29. ^ Ghose, Tia (17 February 2016). "Medieval Shipwreck Hauled from the Deep". Live Science. Archived from the original on 7 July 2017. Retrieved 14 September 2017.
  30. ^ "Late Medieval Cog from Kampen". Medieval Histories. 21 February 2016. Archived from the original on 14 September 2017. Retrieved 14 September 2017.
  31. ^ "Lost 700-year-old ship found just five feet beneath street by construction workers". metro.co.uk. 20 April 2022. Retrieved 4 October 2023.

Sources

edit
edit
 
Wikimedia Commons has media related to Cogs (ships).
Retrieved from "https://en.wikipedia.org/w/index.php?title=Cog_(ship)&oldid=1254739586"