Doubly fed induction

The objective of this paper is to study the dynamic response of the wind energy conversion system (WECS) based on the Doubly Fed Induction Generator (DFIG). The DFIG rotor is connected to the grid via a converter. The active and reactive power control is realized by the DFIG rotor variables control, using the field oriented control (FOC). The vector control of DFIG is applied by the use of tow regulators PI and the neural network regulator (NN). The generator mathematical model is implemented in Matlab/ Simulink software to simulate a DFIG of 1.5 MW in order to show the efficiency of the performances and robustness of the studied control systems. The simulation obtained results shows that the robustness and response time of the neural network regulator is better than those obtained by the PI classical regulator.

The objective of this paper is to study the dynamic response of the wind energy conversion system (WECS) based on the Doubly Fed Induction Generator (DFIG). The DFIG rotor is connected to the grid via a converter. The active and reactive power control is realized by the DFIG rotor variables control, using the field oriented control (FOC). The vector control of DFIG is applied by the use of tow regulators PI and the neural network regulator (NN). The generator mathematical model is implemented in Matlab/ Simulink software to simulate a DFIG of 1.5 MW in order to show the efficiency of the performances and robustness of the studied control systems. The simulation obtained results shows that the robustness and response time of the neural network regulator is better than those obtained by the PI classical regulator.

Wind turbine is one of the present renewable energy sources that has become the most popular. The operational and maintenance cost is continuously increasing, especially for wind generator. Early fault detection is very important to optimise the operational and maintenance cost. The goal of this project is to study fault detection and classification for a wind turbine (WT) by using artificial neural network (ANN). In this project, a single phase fault was placed at 9 MW doubly-fed induction generator (DFIG) WT in MATLAB Simulink. The WT was tested under different conditions, i.e., normal condition, fault at Phase A, Phase B and Phase C. The simulation results were used as inputs in the ANN model for training. Then, a new set of data was taken under different conditions as inputs for ANN fault classifier. The target outputs of ANN fault classifier were set as '0' or '1', based on the fault condition. Results obtained showed that the ANN fault classifier outputs had followed the target outputs. In conclusion, the WT fault detection and classification method by using ANN were successfully developed.