Aerospace Eng.

Gels are non-Newtonian fluids that exhibit shear thinning behavior, and in general, they are more difficult to atomize in comparison to the liquids they are based on. To improve the gel spray characteristics, periodic disturbances were introduced on the atomized fluid jet, at the exit plane of a triplet air-blast atomizer. An experimental system that imposed periodic, constant-amplitude disturbances with controllable frequencies between 100 and 1100 Hz was designed and built. Water and water-based carbopol gels were used as atomized fluids at flow rates between 5 and 22 g/s. In most cases, the experiments showed a reduction in the Sauter mean diameter of the spray between 25% and 60%, depending on the gellant content, mass flow rate, and air-to-liquid ratio. In an originally bimodal spray, an increasing dominance of the small droplet mode with increasing disturbance frequency was observed.

Recently, an improved chemical mechanism of PAH growth was developed and tested in soot computations for a laminar co-flow non-premixed ethylene–air diffusion flame [Dworkin et al., Combust. Flame 158(9) (2011) 1682–1695]. With the intention of testing the robustness of the solution methodology on partially-premixed systems, this work used the same algorithm as that in the study of Dworkin et al. for computations of two sets of sooting partially-premixed co-flow laminar ethylene–air flames. The results show very good qualitative and good quantitative agreement with the experimental results for soot volume fractions and soot precursors, without any changes to the parameters of the model. The soot yield was found to initially increase with decreasing primary equivalence ratios, and then to decrease for Φ < 24, reaching levels lower than the non-premixed case for Φ < 10. On the flame centerline, both PAH and acetylene-related processes were found to be important for soot growth. The initial increase in the soot yield was linked to higher inception rates. On the wings of the flame the dominant soot growth process was found to be HACA growth. The initial increase in the soot yield was mostly due to higher acetylene yield leading to faster surface growth. The primary air was also found to influence the soot oxidation process by increasing OH radicals in both the centerline and the wings region.

Thin layers with material properties which differ significantly from those of the adjacent media appear in a variety of applications, as in the form of fiber coatings in composite materials. Fully modeling of such thin layers by standard finite element (FE) analysis is often associated with difficult meshing and high computational cost. Asymptotic procedures which model such thin domains by an interface of no thickness on which appropriate interface conditions are devised have been known in the literature for some time. The present paper shows how the first-order asymptotic interface model proposed by Bövik in 1994, and later generalized by Benveniste, can be incorporated in a FE formulation, to yield an accurate and efficient computational scheme for problems involving thin layers. This is done here for linear scalar elliptic problems in two dimensions, prototyped by steady-state heat conduction. Moreover, it is shown that by somewhat modifying the formulation of the Bövik-Benveniste asymptotic model, the proposed formulation is made to preserve the self-adjointness of the original three-phase problem, thus leading to a symmetric FE stiffness matrix. Numerical examples are presented that demonstrate the performance of the method, and show that the proposed scheme is more cost-effective than the full standard FE modeling of the layer.