Skip to main content

Stack Exchange

S.s.

http://none

I love beer!

top accounts reputation activity subscriptions
Top Questions
22 votes

How does a DC clamp meter measure current?

multimeter amperage induction asked Nov 22, 2017 at 1:20
electronics.stackexchange.com

18 votes

Constant current, constant power and constant impedance loads

power-supply current impedance load asked Aug 26, 2012 at 18:00
electronics.stackexchange.com

13 votes

What makes open/short/load (OSL) calibrators so expensive/sophisticated?

calibration vna asked Aug 26, 2020 at 2:46
electronics.stackexchange.com

11 votes

Superposition principle: Dependent sources treated as independent sources

circuit-analysis superposition asked Apr 21, 2014 at 22:22
electronics.stackexchange.com

10 votes

Adding a resistor to reduce crossover distortion in an LM324/LM358

op-amp linear distortion asked Nov 26, 2017 at 1:32
electronics.stackexchange.com

8 votes

Opamp noise: When is a resistor in the signal path?

op-amp noise asked Dec 5, 2018 at 2:43
electronics.stackexchange.com

8 votes

Wideband matching network design

rf impedance-matching bandwidth asked Nov 7, 2017 at 1:31
electronics.stackexchange.com

8 votes

Isolation transformer and scope when troubleshooting SMPS

transformer oscilloscope switch-mode-power-supply isolation troubleshooting asked Aug 3, 2012 at 18:52
electronics.stackexchange.com

7 votes

How does current flow through a voltage source?

voltage current dc basic asked Nov 19, 2012 at 19:18
electronics.stackexchange.com

7 votes

Voltage and current calculations, Resistor and inductor in parallel

resistors inductor asked Jul 10, 2013 at 19:31
electronics.stackexchange.com

1 2

Top Answers