All Questions
Tagged with sepic inrush-current
2 questions
1
vote
0
answers
263
views
How to limit starting current of a SEPIC based LED driver?
I have designed a SEPIC based LED driver which gives 60 V, 350 mA constant output with a good power factor. It is connected with 220 V AC source.Then I have used full-wave rectifier.After ...
0
votes
1
answer
314
views
PWM Dimming results in input ripple due to excessive inrush current
I use a constant current SEPIC boost regulator ([TI LM3410X) to run a 8.5V 400mA OLED panel from a single Cell Lithium polymer battery. I have noticed that the input voltage ripple is too much (~1V ...