/**

* The MySensors Arduino library handles the wireless radio link and protocol

* between your home built sensors/actuators and HA controller of choice.

* The sensors forms a self healing radio network with optional repeaters. Each

* repeater and gateway builds a routing tables in EEPROM which keeps track of the

* network topology allowing messages to be routed to nodes.

*

* Created by Henrik Ekblad <[email protected]>

* Copyright (C) 2013-2015 Sensnology AB

* Full contributor list: https://github.com/mysensors/Arduino/graphs/contributors

*

* Documentation: http://www.mysensors.org

* Support Forum: http://forum.mysensors.org

*

* This program is free software; you can redistribute it and/or

* modify it under the terms of the GNU General Public License

* version 2 as published by the Free Software Foundation.

*

*******************************

*

* DESCRIPTION

* The ArduinoGateway prints data received from sensors on the serial link.

* The gateway accepts input on seral which will be sent out on radio network.

*

* The GW code is designed for Arduino Nano 328p / 16MHz

*

* Wire connections (OPTIONAL):

* - Inclusion button should be connected between digital pin 3 and GND

* - RX/TX/ERR leds need to be connected between +5V (anode) and digital pin 6/5/4 with resistor 270-330R in a series

*

* LEDs (OPTIONAL):

* - To use the feature, uncomment MY_LEDS_BLINKING_FEATURE in MyConfig.h

* - RX (green) - blink fast on radio message recieved. In inclusion mode will blink fast only on presentation recieved

* - TX (yellow) - blink fast on radio message transmitted. In inclusion mode will blink slowly

* - ERR (red) - fast blink on error during transmission error or recieve crc error

*

*/

// Enable debug prints to serial monitor

#define MY_DEBUG

// Enable and select radio type attached

#define MY_RADIO_NRF24

//#define MY_RADIO_RFM69

// Set LOW transmit power level as default, if you have an amplified NRF-module and

// power your radio separately with a good regulator you can turn up PA level.

#define MY_RF24_PA_LEVEL RF24_PA_LOW

// Enable serial gateway

#define MY_GATEWAY_SERIAL

// Define a lower baud rate for Arduino's running on 8 MHz (Arduino Pro Mini 3.3V & SenseBender)

#if F_CPU == 8000000L

#define MY_BAUD_RATE 38400

#endif

// Flash leds on rx/tx/err

// #define MY_LEDS_BLINKING_FEATURE

// Set blinking period

#define MY_DEFAULT_LED_BLINK_PERIOD 300

// Inverses the behavior of leds

//#define MY_WITH_LEDS_BLINKING_INVERSE

// Enable inclusion mode

//#define MY_INCLUSION_MODE_FEATURE

// Enable Inclusion mode button on gateway

//#define MY_INCLUSION_BUTTON_FEATURE

// Inverses behavior of inclusion button (if using external pullup)

//#define MY_INCLUSION_BUTTON_EXTERNAL_PULLUP

// Set inclusion mode duration (in seconds)

#define MY_INCLUSION_MODE_DURATION 60

// Digital pin used for inclusion mode button

#define MY_INCLUSION_MODE_BUTTON_PIN 3

// Uncomment to override default HW configurations

#define MY_DEFAULT_ERR_LED_PIN 7 // Error led pin

#define MY_DEFAULT_RX_LED_PIN 5 // Receive led pin

#define MY_DEFAULT_TX_LED_PIN 6 // the PCB, on board LED

#include <SPI.h>

#include <MySensors.h>

void setup() {

// Setup locally attached sensors

}

void presentation() {

// Present locally attached sensors

}

void loop() {

}