Proximity effect (audio)

The proximity effect in audio is an increase in bass or low frequency response when a sound source is close to a microphone.

Technical explanation

Proximity effect is distortion caused by the use of ports to create directional polar pickup patterns, so omni-directional mics are not affected. Depending on the mic design, proximity effect may easily result in a boost of up to 16 dB, usually focused below 100 Hz. Vocalists tend to like proximity effect, since it fattens up their voice, but a constantly varying bass boost can wreak havoc on headroom and carefully set levels. Proximity effect is sometimes referred to as "bass tip-up."

Angular dependence

To explain how the proximity effect arises in directional microphones, it is first necessary to briefly describe how a directional microphone works. A microphone is constructed with a diaphragm whose mechanical movement is converted to electrical signals (via a magnetic coil, for example). The movement of the diaphragm is a function of the air pressure difference across the diaphragm arising from incident sound waves. In a directional microphone, sound reflected from surfaces behind the diaphragm is permitted to be incident on the rear side of the diaphragm. Since the sound reaching the rear of the diaphragm travels slightly farther than the sound at the front, it is slightly out of phase. The greater this phase difference, the greater the pressure difference and the greater the diaphragm movement. As the sound source moves off the diaphragm axis, this phase difference decreases due to decreasing path length difference. This is what gives a directional microphone its directivity.

In addition to the angular dependence described above, the response of a directional microphone depends on the amplitude, frequency and distance of the source. These latter two dependencies are used to explain the proximity effect.

Phase difference

As described above, the phase difference across the diaphragm gives rise to the pressure difference that moves the diaphragm. This phase difference increases with frequency as the difference in path length becomes a larger portion of the wavelength of the sound. This frequency dependence is offset by damping the diaphragm 6 dB per octave to achieve a flat frequency response (but this is not germane to the proximity effect so nothing more will be said about it here). The point to be made regarding the frequency dependency is that the phase difference across the diaphragm is the smallest at low frequencies.

Amplitude difference

In addition to phase differences, amplitude differences also result in pressure differences across the diaphragm. This amplitude component arises from the fact that the far side of the diaphragm is farther from the sound source than the front side. Since sound pressure level decreases as the inverse of the distance from the source (it is sound intensity level that drops as the inverse of the distance squared, for those familiar with the inverse square law), the amplitude of the sound will be slightly less at the rear of the diaphragm as compared to the front of the diaphragm. Since the pressure difference due to the amplitude component is dependent only on the amplitude differential with respect to the two sides of the diaphragm, it is independent of frequency, per se.

The properties of the amplitude component that are applicable to the proximity effect are that the contribution to the pressure difference is small and independent of frequency. At large distances between the source and the microphone, the amplitude component of the pressure difference is negligible compared to the phase component at all audio frequencies. As the source is brought closer to the directional microphone, the amplitude component of the pressure difference increases and becomes the dominant component at lower frequencies (recall that the phase component is relatively small at the low frequencies). At higher frequencies, the phase component of the pressure difference continues to dominate for all practical distances between source and microphone.

The result is that the frequency response of the microphone changes; specifically, it increases at the low frequency (bass) end, as the audio source is brought closer to the microphone. This is the proximity effect as it pertains to audio.