Skip to main content

All Questions

Tagged with
Filter by
Sorted by
Tagged with
0 votes
0 answers
81 views

Can anyone identify this surface-mount sensor?

The picture shows a part of a brushless motor. The sensor looks like it may be a Hall-effect sensor, but I'm not sure. Can anyone help me identify it?
HNLinh's user avatar
  • 347
1 vote
1 answer
181 views

Digital Hall sensor only connects to ground when active

I want to make a power control circuit that turns off when a digital hall sensor detects a magnet. All digital hall sensors I have found connect to ground when active. I was thinking about using a ...
OpticalOpal's user avatar
0 votes
0 answers
116 views

How can I measure switching power losses in a MOSFET accurately?

I am going to measure under scope the switching power losses in the MOSFETs of my micro power inverter. In any case, the handling load current doesn't exceed 1 A at 24/48 Vrms. Firstly, I've thought ...
settimed's user avatar
0 votes
1 answer
589 views

Need Hall sensor output to be 5 volts (high) instead of 0 volts (low) when magnet detected

First time asking a question here. I have a Hall sensor A3144 that goes to low when a magnet activates it. So I can use a magnet with it to complete a circuit, say, connecting the output to a red LED ...
Wade Martin's user avatar
1 vote
2 answers
857 views

hall effect sensor as a toggle swich for a 12v strip of LEDs

I'm trying to use a unipolar hall effect sensor as a power switch to turn off and on a 12V strip of LEDs, powered by a 12V 6.6Ah battery. I just tested the current draw of the LED strip with a ...
Matty D's user avatar
  • 37
7 votes
2 answers
14k views

Reduce noise from a Hall effect sensor

I am currently working on a magnetic levitation project using a Hall effect sensor for distance measurement. I drive the coil using two 12 V car batteries in series to form a 24 V DC source, ...
Torben's user avatar
  • 81
0 votes
3 answers
1k views

Why do I need I large resistor to the GATE of my MOSFET?

I tried to control the brightness of a LED using a Linear Hall Effect Sensor fed to an Arduino, and PWM output to the gate of a MOSFET connected to a 12V battery. The LED was flickering a lot, and ...
Torben's user avatar
  • 81